CNC Router 2.0

As many times as not, when I hear the term “new and improved” it winds up being an eye-rolling event. But the upgrades that Chris Fitch endowed this version of our CNC router is impressive. Compared to the first iteration that was presented, there are three improvements that make all the difference. First, as you see in the photo above the worksurface is wider (the Y direction), allowing for a full 24"" routing area. Second, since the electronics box is not attached to the bed of the machine — but tethered by a length of sheathed wiring — you can stow it out of the way and have an unlimited X direction to play with. To complete the trifecta, notice the T-tracks embedded in the end of the base — this lets you clamp boards vertically to rout joinery in the ends of workpieces. These improvements combined with the cost savings versus a manufactured machine should have you rolling up your sleeves and heading to the shop.

Product Recommendations

We don't have any links to project supplies and hardware for this particular project yet, but here are some other products that might be of interest to you. (We may receive commission when you use our affiliate links. However, this does not impact our recommendations.)